Skip to main content

Error Messages

Printer error messages​

Can not update MCU ‘mcu’, error configuring printer.​

  • Check if all cables from the screen to the printer are connected correctly.

Create or login

Shutdown due to webhook request.​

This is an emergency stop.

  • Check if the x & y offsets are movable
  • Check if the printer is on 4 legs (is it shaking?)

Create or login

Heater extruder not heating at expected rate.​

  • Solution 1: Check if nozzle sock is torn -> if torn, replace the sock and try again.
  • Solution 2: do a PID calibration. (Click on temprature, insert 270 degrees, and click on calibrate)

Belt cracking.​

  • Belt too tightened, loosen belt.

Layer shift.​

  • Check if belt is too tight, loosen belt.